Stripers247.com Forums - View Single Post - Tail Weight Molds?
View Single Post
  #6  
Old 09-13-2014, 07:02 PM
Micodese Micodese is offline
Striper Hunter
 
Join Date: Jun 2014
Location: Long Island
Posts: 10
Default Re: Tail Weight Molds?

Yes I know this is a little old and not sure who is on here still beside Roccus. Anyway this is what I did running into the same problem with pencils. I used a 3/8 (I believe off hand) and the a little bigger than a 1/8 drill bit on the bottom. It actually works good. I would post a picture but when I try to it tells me to enter a web page. If anyone can help please do and so I could show you the photo of it.
Reply With Quote