Stripers247.com Forums - View Single Post - filling small holes in hull
View Single Post
  #1  
Old 07-12-2007, 01:20 PM
colad's Avatar
colad colad is offline
in awe of real fisherman
 
Join Date: Jul 2006
Location: Douglas, MA
Posts: 236
Default filling small holes in hull

Hi,
I just purchased a new fishfinder to replace my old one and the transom mount is different so I will need to drill new holes. This will leave three holes from the old mount. Is there a recommended way to fill them and make them water tight or is it basically lust fill them with marine grade sealer and I am good to go? any advice is welcome, since they are below the waterline I would prefer not to sink my boat :)
Thanks!
Reply With Quote